Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem somewhat old-fashioned but it's still eye-catching. It's not the most luxurious car in its class, but it's an enjoyable and comfortable drive.
We are often asked at Coded Car Keys to replace peugeot key fobs. No matter if the issue is ongoing or continuous, the following tips should assist.
Water Damage
When you accidentally leave your key fob in a pool or splash it with water when kayaking, swimming, canoeing, rafting, or canyoning, it's more likely to suffer water damage. Keep your key fob in a dry bag every time you go outside or engage in activities that could expose it to excessive amounts water.
It's also essential to make sure that the fob has dried out before you open it to use it again. If you smell any odors from the fob (such as industrial liquid or windshield washer fluid) This is a further indicator that it is submerged.
A circuit that is wet can cause the battery's power to be depleted or even explode. If you can get your keyfob 308 out of the water, turn the button side up and shake as much water as you can before opening the casing. Remove the battery, then clean the circuit board with a cotton swab, which has been dipped into 90-percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system might not work include a dead coin cell battery or receiver module issues, signal interference or a malfunctioning chip. If none of these is the reason, you may try resetting the system by disconnection of the battery with 12 volts for around 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that lets drivers start their vehicle from an extended distance, which allows them to warm up or cool down the vehicle prior to entering. This feature is extremely beneficial particularly during the cold winter months. The remote start system may stop working for a variety reasons, including a dead coin-battery.
The coin-shaped battery that is inside the key fob will last between two and four years, based on how frequently it is used, where it was purchased and how it is utilized. The date of use is typically found on the packaging or in the manual.
If the key fob stops working after exposure to water that is clean, remove the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip completely before replacing. If exposed to soapy or salty water, the chip may be damaged and you'll require replacing the key fob entirely.
If you're unsure if that the battery is not working properly you can check its voltage using an instrument set to the car's voltage range, and connect it to the minus and plus terminals. The voltage should be around 12-13 volts, but if it's lower, the battery needs to be replaced. You can also try to reset the onboard computer by disconnecting the 12 volt battery for a couple of minutes, and then reconnecting it in reverse order (positive cable first and then negative). The engine should start after this.
Faulty Receiver Module
If you aren't seeing the "Key Detected" you might find that your receiver module is defective. It's the part that sends out the signal when your key fob activates. It also acts as an alarm that stops the car from starting without the correct key.
This can be due to many causes, such as water damage or simply getting old. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the electronic chip on the inside will be damaged. In this case it is necessary to take the device apart and clean it thoroughly with isopropyl or electronic cleaner. Once it's dry you can put the battery back in and try it again.
If the problem persists you're probably in need of a idea to seek out an area Peugeot specialist or locksmith. They'll be able employ a diagnostic tool assist in identifying the problem and fix it.
The loss of your Peugeot keys to your car can be an extremely stressful experience. However, a trained auto locksmith can fix the issue in only a few minutes. peugeot 207 key fob G28CarKeys can program your vehicle and cut a new functioning key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip inside the Peugeot 308 key fob is a critical role in the remote control system. If it becomes damaged, your car may not start or you might receive a message saying "anti-theft active". If this happens, the only way to fix the issue is to replace the key. Luckily, auto locksmiths who are professionals can provide the service in the shortest time.
The chip inside your Peugeot 308 key fob can be damaged by sweat, water damage dirt, or any other cause. If your Peugeot key fob has been exposed to dirty or soapy water, it needs to be cleaned immediately. You can wipe the electronic component with the help of a towel that is soaked in isopropyl Alcohol. Then, you need to allow the battery to completely dry.
Radio interference can cause a key fob's functionality to cease. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. It could be caused by bad conditions or objects near to the vehicle. It is recommended to see a Peugeot dealer if you encounter this issue.
The Peugeot Key Fob 207/308 is delicate and requires special care. You should not drop it or throw it around. If you lose it, try to locate it as quickly as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Be sure to disconnect the negative cable first, then the positive.